-
<li>Prepare your firmware dd-wrt mini version
- Turn on your Linksys WRT54GL
- Keep on pressing reset button on the back of WRT54GL for few minutes
- Connect your computer using UTP to port LAN on the back of WRT54GL
- Set your IP use the IP statistic
- If you use Windows , open two commands prompt. Type on the first command “ping-t 192.168.1.1″. But if you use Linux program you can open two consoles then let it run
- Give “tftp” in second command or console
- The in tftp prompt run this command “tftp>connect 192.168.1.1
- tftp>binary
- tftp>Put dd-WRT.v24_mini_generic.bin
- that is the last step of flashing. And don’ press any key during flashing process.
source: michael.sunggiardi.com
